Table of Contents
Advertisement
Chapter 10. Dial Plan Terminal Menu
QUAD T1/PRI MODULE (USER TERMINATION/PRI)
»» Switch Type
»» First DS0
»» Number of DS0s
» Strip MSD
» Network Specific
Facility Voice
» Network Specific
Facility Data
10-14
•
When creating the Call Accept list, specify a Source ID( s) as well as a
dialed number or range of dialed numbers to accept.
For example, an application requires that all calls originating from Port 1 of
the Quad T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. Assign a unique Source ID (e.g., 7) to Port 1 of the module, and then
configure Port 4 to only accept calls from that unique Source ID (7).
When you are working in the User Termination section of the Dial Plan
menu, the Slot is defined as a T1/PRI module, and Sig is set to PRI, the fol-
lowing configuration options are available:
Write security: 3; Read security: 5
Defines the type of PRI switch that ATLAS is going to emulate. If connected
to another ATLAS, both need to be set to the same type. Options include
Lucent 5E and AT&T 4ESS.
Write Security: 3 Read Security: 5
Defines to ATLAS the first active DS0.
Write Security: 3 Read Security: 5
Defines the number of DS0s used for calls on this PRI. DS0 24 is assumed to
be used by the PRI for the D channel.
Write Security: 3 Read Security: 5
This option allows a selected quantity of the Most Significant Digits (MSD)
of a dialed number for ATLAS to be stripped prior to being forwarded out
of the port.
For example, a Network port could be set to accept all calls beginning with
9 (9$), and then with Strip MSD set to 1, all digits would be sent toward the
Network except the leading 9.
The Strip MSD parameter does not affect the Call Accept criteria.
All of the digits (including the MSDs that are subsequently
stripped) are used as accept criteria.
Write Security: 3 Read Security: 5
Defines the specific facility IEs to send to the Network. Use this option if the
customer has subscribed to a network specific facility service such as AT&T
Megacom service. The facility request sent can be different for voice calls
versus data calls. A setting of
been subscribed.
Write Security: 3 Read Security: 5
Defines the specific facility IEs to send to the Network. Use this option if the
customer has subscribed to a network specific facility service such as AT&T
Megacom service. The facility request sent can be different for voice calls
PLUS
ATLAS 800
indicates no special facilities have
Normal
User Manual
61200226L1-1
Advertisement
Table of Contents
