Network Term; Slot/Svc; Port/Pep; Out#Accept - ADTRAN ATLAS 800 PLUS User Manual

NETWORK
>
TERM
» Slot/Svc
» Port/PEP
» Sig
» Out#Accept
»» Src ID
61200226L1-1
This menu allows the user to define option parameters for ports which ter-
minate a connection from the Network (PSTN).
In applications where two ATLAS units are used in a point-to-
point configuration, a port in the ATLAS at one end would act as
the Network (User Termination), while the ATLAS at the opposite
end would be terminating a "Network" connection.
Write security: 3; Read security: 5
Select the ATLAS slot that terminates a Network connection.
Write security: 3; Read security: 5
Select the ATLAS port that terminates a Network connection.
There may be more than one "end point" associated with a
particular port. If a T1 is connected to the PSTN, some DS0s may
be used for long distance, while others are used for local calls. These
would constitute two "end points" (trunks) over a single physical
port.
Write security: 3; Read security: 5
Defines the type of signaling being used for this connection (end point).
RBS would be for a T1 using Robbed Bit Signaling while PRI designates a
Primary Rate ISDN interface. This selection is only necessary if a T1/PRI is
selected as the Slot/Port type.
Write security: 3; Read security: 5
Defines the parameters for the outgoing calls that ATLAS sends to the Net-
work.
Write Security: 3 Read Security: 5
Identifies the call source ID from which this endpoint accepts calls This
field simplifies the creation of a Dial Plan in applications where the crite-
rion for switching calls to a certain endpoint is a function of which endpoint
originated the call. Source ID may be entered with the usual wild card
entries (except $)
X = any digit 0—9
[1,3,5] = any of these digits
Default value = 0. The default ID for all Source endpoint is 0 and all accept
#'s is 0. This results in all calls being routed based on the dialed number.
PLUS
ATLAS 800
Chapter 10. Dial Plan Terminal Menu
User Manual 10-3