Table of Contents
Advertisement
» Automatic
Routeback
Rejection
QUAD T1/PRI MODULE INTERFACE CONFIGURATION
Quad T1/PRI Module (Network Termination/PRI)
»» Switch Type
»» First DS0
61200226L1-1
#
Denotes an Entry Number (MAX 50). Press INS/DEL to in-
sert/delete any entry.
Prefix
Sets the prefix for the number type. Only digits 0 and 1 are
allowed (MAX 6).
Pattern
Modifies an entry when you press Enter (MAX 40).
Number Typ
Lists valid selections when you press Enter .
Write security: 1; Read security: 5
When enabled, Automatic Routeback Rejection prevents calls which
enter through network termination interfaces from being forwarded out
another network interface. Such an event could happen if an incoming call
specifies a number that has no endpoint configured to accept it and another
network interface has a call acceptance entry which could accept it (such as
$). Without automatic rejection, such a call would be forwarded back to the
Network. The Network would in turn resend the call to the unit until all
incoming resources are consumed.
Use extreme caution when disabling this option!
For information on Circuit Backup Configuration, refer to
Dedicated Circuit Backup and Circuit Status on page 9-1.
This section describes the Network Termination and User Termination con-
figuration settings for the Quad T1/PRI module when using the Dial Plan
menus.
When you are working in the Network Termination section of the Dial Plan
menu, the Slot is defined as a T1/PRI module, and Sig is set to PRI, the fol-
lowing configuration options are available:
Write security: 2; Read security: 5
Defines the type of PRI switch that ATLAS is connected to. If connected to
another ATLAS, both need to be set to the same type. The available options
include Lucent 5E, Northern DMS 100, National ISDN, and AT&T 4ESS.
Write Security: 3 Read Security: 5
Defines the first active DS0 for a fractional PRI.
PLUS
ATLAS 800
Chapter 10. Dial Plan Terminal Menu
User Manual
10-9
Advertisement
Table of Contents
