Data 64K, Data 56K; Out#Rej; Reject Number; Data 56K, Data 64K, Audio, Speech - ADTRAN ATLAS 800 PLUS User Manual

»» Data 64K, Data 56K
» Out#Rej
»» Reject Number
»» Data 56K, Data 64K,
Audio, Speech
» Ifce Config
61200226L1-1
Primary
The Search parameter instructs ATLAS which order to
Search search for an accept number match. Normally all searches
are set to Primary. The Secondary search selection would be
used to force ATLAS to only accept a call at this end point if
all Primary end points were unavailable.
For example, all long distance calls should go out a PRI di-
rectly to an IXC (MCI, ATT, etc.) and local calls should go out
a T1 to the LEC. It may be desirable to place long distance
calls on the local exchange if all of the IXC trunks are un-
available (busy or in alarm). In this case, the primary accept
number for the local exchange would be N$, and the second-
ary accept would be 1$.
Secondary The same accept rules apply for all secondary number
Search searches as for primary searches.
Write security: 3; Read security: 5
This reflects the bearer capability that the attached user equipment (typi-
cally a TA) has. If the attached TA can only handle digital calls, then a
voice call sent to this end point would be rejected.
Write security: 3; Read security: 5
Defines the parameters for outgoing calls that ATLAS 800
to the Network.
This field designates which numbers this particular end point will NOT
pass on toward the Network (PSTN). This is used when the outgoing call
filter is different for different users. The "wild cards" are identical as in Out-
going Call Accept. For example, if desired, each user termination port can
be set to reject different numbers.
[0,1]-$ would reject all long distance calls, but only for this user
termination. If permitted in the Network Termination end point,
this user could not dial long distance numbers while other users
could.
These items allow ATLAS 800
type. For example, a "$" for the Reject Number, Digital 56/64 enabled, and
Audio & Speech Disabled would reject all digital calls while not rejecting
analog calls.
This list may remain blank if the Accept List meets desired filtering.
The Call Reject list takes precedence over the Call Accept list.
Sets configuration parameters for the end point. These parameters vary by
the type of port selected. For detailed information on the interface configu-
ration, see Quad T1/PRI Module Interface Configuration on page 10-9.
PLUS
ATLAS 800
Chapter 10. Dial Plan Terminal Menu
PLUS
to reject outgoing calls based on call
User Manual
PLUS
will not send
10-7