Using Telnet - ADTRAN ATLAS 800 PLUS User Manual

Using Telnet

61200226L1-1
To connect to the ATLAS 800
subnet mask, and, typically, wet the default gateway IP address. The follow-
ing Step/Action tables provide instructions for performing these tasks.
You must define the IP address before attempting to connect via
Telnet.
Instructions for Defining the IP Address
Step
Obtain an IP address for the ATLAS 800
1
administrator.
From the Front Panel, select 2) CONFIG, then S0) SYSTEM, then
2
1) ETHERNET.
3
When the submenu displays, select 1) IP ADDRESS.
Enter the IP address by entering each number followed by Enter
4
to move to the next field.
5
Press Enter after keying in the entire IP address.
Instructions for Setting the Subnet Mask
Step
1 Obtain a subnet mask address from your LAN administrator.
From the Front Panel, select 2) CONFIG , then S0) SYSTEM , then
2
1) ETHERNET .
3 When the submenu displays, select 2) SUBNET MASK .
Enter the subnet mask by entering each number followed by
4
Enter to move to the next field.
5 Press Enter after keying in the entire subnet mask address.
PLUS
ATLAS 800
Chapter 3. Operating the ATLAS 800PLUS
PLUS
via Telnet, define the IP address, set the
Action
PLUS
Action
User Manual
from your LAN
3-3