Table of Contents
Advertisement
Chapter 3. Operating the ATLAS 800PLUS
Starting a Telnet Session
Using VT-100 Terminal Emulation
3-4
Instructions for Setting the Gateway IP Address
Step
From the Front Panel, select 2) CONFIG , then S0) SYSTEM , then
1
1) ETHERNET .
2
When the submenu displays, select 3) DEF GATEWAY .
Enter the default gateway by entering each number followed by
3
Enter to move to the next field.
4
Press Enter after keying in the entire address.
You will need a default gateway if the LAN contains multiple
segments. Contact your LAN administrator for the appropriate
address.
When you begin the Telnet session, you will be prompted for a password.
The default password is password (which is a Level 0 superuser password).
You can change this password using the Access Passwords option, which
is only accessible through the terminal menus. See Access Passwords on page
6-11 for details. The Telnet session will time out and display the Login
prompt after a pre-defined time that is set in the Session Timeout option
(see Session Timeout on page 6-8 for details).
Use the Max Telnet Sessions option to define the number of
Telnet sessions that can be active at one time (see Max Telnet
Sessions on page 6-8 for details).
Microsoft Telnet version 1.0 does not implement full VT-100
emulation. However, many commercial Telnet clients for Microsoft
Windows exist which fully implement VT-100. In addition, a
freeware client which is recommended for optimum performance is
delivered with the ATLAS 800
13-8 for details.
An EIA-232 serial connection is available via the Chain In port on the rear
panel of the ATLAS 800
menus to a VT-100 type terminal. The following Step/Action table provides
instructions for setting up the ATLAS 800
PLUS
ATLAS 800
Action
PLUS
. See VT-100 Utility on page
PLUS
PLUS
. The ATLAS 800
PLUS
for VT-100 terminal mode.
User Manual
provides the Front Panel
61200226L1-1
Advertisement
Table of Contents
