Chapter 8. Dedicated Maps Terminal Menu
Defining the Connections
8-8
Begin by navigating to Dedicated Maps / Create/Edit Maps and naming
your map.
Navigate to Dedicated Maps / Connects . The Connects submenu defines
the connections necessary to route the required bandwidth. Refer to Table 8-
1 to define each of the necessary connections. For this procedure, first define
the data connections, and then define the voice connections. The following
Step/Action tables guide you through this process. (Figure 8-5 shows the
completed map.)
Instructions for Defining Data Connections
Step
1
For Data A, select and define FROM Slot (i.e., 0 Sys Ctrl ).
2
Select and define "from" Port (i.e., port 1 for T1: Data A).
3
Select and define From Config DS0s (i.e., DS0=9-24 ).
Select and define TO Slot and "to" Port in the same way (i.e.,
4
2 V.35Nx4 and 1 where 2 = Slot 2 and 1 = Port 1.)
5
From To Config , set V.35 to operate at 56k/64k per DS0.
Repeat for the remaining data connections (i.e., Data B and
6
Data C) as follows:
Insert new connection lines by positioning the cursor over the
6a
index # of the first connection and pressing
Copy the first connection by positioning the cursor on the index #
6b
and pressing
C
PLUS
ATLAS 800
Figure 8-4. Slot 0 Module Configuration Menu
Action
.
User Manual
I
.
61200226L1-1