Table of Contents
Advertisement
Chapter 3. Operating the ATLAS 800PLUS
USING THE TERMINAL MENU
3-2
S0) SYSTEM
2) CONFIG
S1)
:
S8)
Figure 3-2. Example of Basic Front Panel Menu Navigation
Setting Up the Unit ID using the Front Panel Menu, CONFIG
Step
Activate CONFIG by pressing the Front Panel arrow keys or by
pressing the number 2 on the Front Panel. (The cursor flashes on
1
the number next to the activated selection.) Press Enter on the
Front Panel.
2
Use the Front Panel Arrow Keys to view the submenu items.
3
Select S0) System . Press Enter on the Front Panel.
Activate 2) Chain Port using the Arrow Keys or by pressing 2 .
4
Press Enter on the Front Panel.
Activate 4) Unit Id using the Arrow Keys or by pressing 4 . Press
5
Enter on the Front Panel.
The Unit Id field displays. Type the new Unit ID in this field and
6
press Enter on the Front Panel. The new Unit ID is now set.
The terminal menu provides a primary means of monitoring and configur-
PLUS
ing the ATLAS 800
. The terminal menu interface uses the full capabili-
ties of the VT-100 terminal to provide the quickest and most intuitive
operation possible. To receive the full benefit of the terminal menu interface,
you should use a fully VT-100 compatible client. The ADTRAN Utilities flop-
py disks (that you can install on a PC) contain both a VT-100 client and a cus-
tomized Telnet program. See ADTRAN Utilities on page 13-1 for details on
the available programs. You can access the terminal menu using a VT-100
terminal or a computer running VT-100 terminal-emulation software.
The two basic connection methods supported by the ATLAS 800
Telnet session and a direct connection through the EIA-232 Chain In port.
The following sections describe using both of these methods.
PLUS
ATLAS 800
1) ETHERNET
2) CHAIN PORT
Action
User Manual
1) BAUD RT 9600
2) FLOW CTL
3) TYPE
4) UNIT ID
5) INIT MODEM
PLUS
are a a
61200226L1-1
Advertisement
Table of Contents
