Session Timeout; Max Telnet Sessions; Ethernet Port; Chain Port - ADTRAN ATLAS 800 PLUS User Manual

Chapter 6. Terminal Menu and System Control
» Session Timeout
» Max Telnet
Sessions
» Ethernet Port
» Chain Port
»» Port Name
6-8
Write security: 3; Read security: 5
Defines the number of seconds the terminal session must remain idle before
the session times out. You can enter zero to deactivate this option (the ses-
sion will never time out).
Write security: 3; Read security: 5
Defines the maximum number of Telnet sessions that can be active at the
same time. Enter a number between 0 and 100 in this field.
If you enter zero in this field, you will not be able to use Telnet. Only
enter zero if you want to completely lock out Telnet access.
Write security: 2; Read security: 5
Provides a way to configure various settings for the Ethernet port. The fol-
lowing options are available for review and editing:

Port Name

Defines the name of the Ethernet port. You can leave this
field blank.
IP Address
Lists the address assigned to the base Ethernet port. This
address is composed of four decimal numbers, each in the
range of 0 to 255, separated by periods. This value is set to
0.0.0.0 by default. The IP address is used for the 10BaseT
Ethernet interface. Obtain the correct IP address from your
LAN administrator.
Default
Defines or changes the default gateway. Enter the default
Gateway gateway address by entering a decimal number into the ap-
propriate field and then pressing
field. You will need a default gateway if the LAN contains
multiple segments. This address is composed of four deci-
mal numbers, each in the range of 0 to 255, separated by pe-
riods. This value is set to 0.0.0.0 by default. Contact your
LAN administrator for the appropriate address.
Subnet Defines which part of a destination IP address contains the
Mask
network number. This address is composed of four decimal
numbers, each in the range of 0 to 255, separated by periods.
This value is set to 0.0.0.0 by default. This part of the desti-
nation IP address is used along with the ATLAS 800
address to determine which nodes must be reached
through the default IP gateway.
Write security: 2; Read security: 5
Accepts input for configuring the chain-in port.
Write security: 2; Read security: 5
Defines the name of the chain port. Type in an alpha-numeric name up to 57
characters long. The name can include spaces and special characters.
PLUS
ATLAS 800
Enter
User Manual
to move to the next
PLUS
IP
61200226L1-1