Setting The Measurement Area - Omron ZW-XC7 User Manual

Setting the Measurement Area

Setting the start and end positions of the measurement area and mask area on the selected measurement
area allows the area used for measurement to be limited.
Cutting out the areas where there is no measurement object makes it possible to measure the object with
stability.
When the measurement object is set to "Glass," measurement may not be performed correctly as
measurement will be influenced by reflection from the rear surface. If this happens, set the measurement area
of each measurement surface so that they can be correctly measured.
Item Setting item
Measurement Measurement
area area (start)
Measurement
area (end)
 Explorer pane
→ Edit pane
→ Sensing settings window : [Measurement area 1]
1
Set the values of [Measurement area (start)]
and [Measurement area (end)].
ZW-7000 User's Manual
Setting value Description
Measuring range Set the measurement start position for the selected measurement area.
of Sensor Head When the window for the selected measurement area is open, the start
[mm] position can also be edited by dragging the start line on the line bright monitor.
Measuring range Set the measurement end position for the selected measurement area.
of Sensor Head When the window for the selected measurement area is open, the end
[mm] position can also be edited by dragging the end line on the line bright monitor.
: [Bank] | [(Bank Data Name)] (double click)
: [Sensing setting] icon ( )
Setting Sensing
103