Table of Contents
Advertisement
Automatically Setting Scaling
Performing 1-point Scaling
Performing 1-point Scaling p.110
Operating procedure
Steps
Key operation
1 to 5
For moving to "SCALE", see steps 1 to 5 in p.207.
6
7
8
9
10
11
12
208
Setting the Output Conditions
Display
Description
Select "AUTO" as the scaling type.
The current setting value is displayed on the sub-display.
Press
Select "AUTO" and press the
Select "1POINT".
Press the
Press the
The current measured value is displayed on the main display and the
current setting value is displayed on the sub-display.
To edit numerical values, use the
Enter the setting value and then press the
Set the increment/decrement direction.
"DIRECT" is displayed on the main display and the incremental/
decremental directions ("FWD": the NEAR side as + and "REV": the
FAR side as +) are displayed on the sub-display.
Press
Enter the setting value and then press the
"OK/CAN" is displayed on the sub-display.
Press the
Press the
/
key to enter editing mode and the sub-display blinks.
key.
/
keys to select "1PT" and press the
key when the main display shows "POINT1".
/
/
key to enter editing mode and the sub-display blinks.
key to execute scaling or
key for two seconds to enter the RUN mode.
key.
/
/
keys.
key.
key.
key to cancel.
ZW-7000 User's Manual
Advertisement
Table of Contents
Troubleshooting
