Omron ZW-XC7 User Manual page 48

l Connectors/terminals
No. Names
21 RS-232C connector
22 Ethernet connector
23 EtherCAT input connector
24 EtherCAT input output connector This connector is used to connect to EtherCAT-compatible devices.
25 24 V input terminal block
26 32-pole extension connector
27 Analog output terminal block
28 Fiber adapter
29 ROM connector
30 Frame ground terminal
Rear view
No. Names
31 DIN track attachment hook
Bottom view
No. Names
32 Installation screw hole
46
Part Names and Functions
Functions
Connect the RS-232C cable when you are connecting the system with a PLC or personal
computer through RS-232C.
For the RS-232C cable, please use the following exclusive products:
If you use a cable not included in the exclusive products, a false operation or breakdown
may result.
• For connecting to a PLC or programmable terminal: ZW-XPT2
• For connecting to a PC: ZW-XRS2
This connector is used to connect with a personal computer through Ethernet.
For Ethernet cable, use a commercially available cable which satisfies the following condi-
tions:
• Category: 5e, or higher and Length: 30m or shorter.
• RJ45 connector (8 pin registered jack)
• When connect 1:1: select Ethernet crossover cable.
• When connect by network HUB: select straight cable.
This connector is used to connect to EtherCAT-compatible devices.
Use the recommended EtherCAT cable.
Use the recommended EtherCAT cable.
This connector is used to connect to Sensor Controller DC24 V power supply. The length
of Cables should be less than 30 m.
• This connector connects the following output and input signals:
• Output signal:
Parallel I/Os, including output for judgment, ALARM, BUSY
ENABLE, Bank Number, SYNCFLG/TRIGBUSY, STABILITY,
LOGSTAT, LOGERR, TASKSTAT
• Input signal:
ZERO, RESET, TIMING, LIGHT OFF, LOGGING,
Bank Number, SYNC/TRIG
• Make sure to use the electric cable within 2m.
This connector connects the output for analog voltage and analog current.
Use the electric cable within 2m.
The fiber adapter connects the fiber connector.
The ROM connector connects the calibration ROM.
This is the connector for frame ground. It connects grounding wire.
Functions
Used when fixing the Sensor Controller on DIN track.
Functions
Used when fixing the Sensor Controller with screws.
ZW-7000 User's Manual