Table of Contents
Advertisement
Class
Name
Parallel
ZERO input
input
RESET input
TIMING input
LIGHT OFF input
BANK_SEL input
LOGGING input
SYNC/TRIG input
68
Wiring
Description
This is used to execute and clear a zero reset.
This resets all executing measurements and outputs.
While a RESET is being input, judgment output conforms to the non-measurement setting.
If this RESET input switches ON while the hold function is used, the state in effect before
the hold function was set will be restored.
This is a signal input from an external device that is used to time the hold function with the
continuous measurement function enabled.
This is a signal input from an external device that is used to time the measurement with the
trigger measurement function enabled.
This LIGHT-OFF signal puts out the measurement LED.
While LIGHT-OFF is being input, the analog output, binary output, and judgment output
conform to the non-measurement setting.
This is used for switching banks.
Specify the bank number in combinations of BANK_SEL1, 2 and 3.
However, if the bank mode is set to "JUDGEMENT", the bank cannot be switched at the
external signal input because the number of banks increases to 32.
Bank Number BANK_SEL1
BANK1
OFF
BANK2
ON
BANK3
OFF
BANK4
ON
BANK5
OFF
BANK6
ON
BANK7
OFF
BANK8
ON
This is used to start and end internal logging.
This is used to synchronize imaging between multiple ZW. With external synchronous mea-
surement mode selected, SYNC/TRIG input works as TRIG input.
BANK_SEL2
BANK_SEL3
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
ON
ON
ON
ON
ZW-7000 User's Manual
Advertisement
Table of Contents
Troubleshooting
