Omron ZW-XC7 User Manual page 64

Masstron Pte Ltd (Singapore)
TEL: (65) 6763 0309
Germany
AMS Technologies AG
TEL: +49 (0)89 895 77 0
France
AMS Technologies S.A.R.L.
TEL: +33 (0)1 64 86 46 00
Italy
AMS Technologies S.r.l.
TEL: +39 0331 596 693
Spain
AMS Technologies S.L.
TEL: +34 93 380 84 20
Netherlands
AMS Technologies AG (Germany)
TEL: +49 (0)89 895 77 0
USA
AFL Telecommunications
TEL: +1 (800) 235-3423
• When you remove the fiber cable from Sensor Controller, make sure to attach the protective cap. If you do not
attach it, it is possible that some contaminants may have adhered and may cause degradation of performance.
• Calibrate the Sensor Head after removing and inserting an optical fiber.
Calibrating Sensor Head p.63
• To check if the fiber is broken, verify the following points:
• When you cannot views the right spot even place within measurement range an object which diffuses light, i.e.
paper while connect the fiber cable correctly, the fiber cable may be damaged. In this case, need to repair. Contact
your OMRON representative.
When inspect a object with high reflectivity, visually check may not be allowable. Use and conform a diffused
object.
• For cleaning of fiber connector and fiber cable using ZW-XCL, refer the following processes.
62
Installation ZW-7000 User's Manual