→ Edit pane: [Sensor Settings] icon (
2
Click [Sensor head calibration].
The [Sensor head calibration] window is ap-
pears.
3
Click [Execute sensor head calibration].
The waveform of received light before calibra-
tion and the waveform of received light after cal-
ibration are shown.
Important
• When Sensor Head calibration fails
If the Sensor Head is calibrated in an inappropriate environment, an error is displayed on the main display. If this
happens, check the environment and try again. If an error results even if Sensor Head calibration is done under the
correct conditions, it is possible that some contaminants may have adhered to the Sensor Head part, or the fiber
connector of the Sensor Controller. Clean the fiber cable or fiber connector referring to p.57. After cleaning the fiber or
fiber connector, be sure to calibrate the Sensor Head again.
• A warning message stating that Re-adjustment is
required will appear on the Multiview Explorer window
for the following.
64
Installation
)
ZW-7000 User's Manual