Table of Contents
Advertisement
3
Select the trigger target.
Item
Trigger target
ZW-7000 User's Manual
Setting item
Range
I/O
TIMING
ZERO
BUSY
ENABLE
HIGH
PASS
LOW
SYNC/TRIG
SYNCFLG
TASK_ENABLE
LOGGING
LOGSTAT
LOGERR
STABILITY
RESET
RESET output
signal (Parallel I/O)
BUFFER_ERR
Data slope
OUT1
Data window (in)
OUT2
Data window (out)
OUT3
OUT4
Description
TIMING input signal (parallel I/O)
ZERO input signal (parallel I/O)
BUSY output signal (parallel I/O)
ENABLE output signal (parallel I/O)
HIGH output signal (parallel I/O)
PASS output signal (parallel I/O)
LOW output signal (parallel I/O)
SYNC input signal (parallel I/O)
SYNCFLG output signal (parallel I/O)
TASK_ENABLE output signal (parallel I/O)
LOGGING input signal (parallel I/O)
LOGSTAT output signal (parallel I/O)
LOGERR output signal (parallel I/O)
STABILITY output signal (parallel I/O)
RESET output signal (Parallel I/O)
Turns ON when the dropping is occurred.
Dropping may be occur depending on the load factor of PC
when acquirement of data from ZW-7000 series. If these
dropping occurs, increase the arguments of logging.
Measurement results assigned to OUT1
Measurement results assigned to OUT2
Measurement results assigned to OUT3
Measurement results assigned to OUT4
Displaying measured values in graphs
147
Advertisement
Table of Contents
Troubleshooting
