Omron ZW-XC7 User Manual page 147

3
Select data to monitor the trend for.
Set data to monitor the trend for.
The types of data that can be set are as follows.
Item
Target data
4
Set the logging sampling interval.
Set the logging sampling interval for the target data.
Item
Sampling setting
5
Click the Start icon (
When the sampling starts, the sampled data is displayed in the graph.
Note
You can also specify the timing (start trigger, end trigger) for the graph display.
6
Click the End icon (
When the sampling ends, the graph display stops too.
ZW-7000 User's Manual
Setting item Description
OUT1 Measurement results assigned to OUT1
OUT2 Measurement results assigned to OUT2
OUT3 Measurement results assigned to OUT3
OUT4 Measurement results assigned to OUT4
TIMING TIMING input signal (parallel I/O)
ZERO ZERO input signal (parallel I/O)
BUSY BUSY output signal (parallel I/O)
ENABLE ENABLE output signal (parallel I/O)
HIGH HIGH output signal (parallel I/O)
PASS PASS output signal (parallel I/O)
LOW LOW output signal (parallel I/O)
SYNC/TRIG SYNC input signal (parallel I/O)
SYNCFLG SYNCFLG output signal (parallel I/O)
TASK_ENABLE TASK_ENABLE output signal (parallel I/O)
LOGGING LOGGING input signal (parallel I/O)
LOGSTAT LOGSTAT output signal (parallel I/O)
LOGERR LOGERR output signal (parallel I/O)
STABILITY STABILITY output signal (parallel I/O)
RESET RESET output signal (ParallelI/O)
BUFFER_ERR Turns ON when the dropping is occurred.
Dropping may be occur depending on the load factor of PC when
acquirement of data from ZW-7000 series. If these dropping occurs,
increase the arguments of logging.
Setting item Range
Data interval 0 to 65535
) to start the sampling.
) to end the sampling.
Description
Set the sampling interval for the target data.
Displaying measured values in graphs
145