Table of Contents
Advertisement
CAUTION:
Use the screws specified in the procedure. Using longer screws can damage the device.
ESD precautions
DANGER
Power precautions
DANGER
DANGER
DANGER
CAUTION:
Use a separate branch circuit for each power cord, which provides redundancy in case one
of the circuits fails.
Lifting precautions
CAUTION:
Use safe lifting practices when moving the product.
18-32 kg (39.7-70.5 lbs)
CAUTION:
A fully populated chassis weighs approximately 145.83 kg (321.5 lbs) and requires a
hydraulic or assisted lift to install it.
18-32 kg (39.7-70.5 lbs)
8
SAN256B-6 Installation, Service, and User Guide
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
If the installation requires a different power cord than the one supplied with the
device, make sure you use a power cord displaying the mark of the safety agency that
defines the regulations for power cords in your country. The mark is your assurance
that the power cord can be used safely with the device.
Make sure that the power source circuits are properly grounded, then use the power
cord supplied with the device to connect it to the power source.
Advertisement
Table of Contents
