Completing The Replacement - IBM SAN256B-6 Installation, Service And User Manual

4. Power up the device.
|
5. Connect the cables to the new CP blades.
|
6. Enter chassisDisable.
|
| 7. Enter configDownload -vf to download device virtual fabric data to the local system. The device
reboots and partitions are restored.
|
8. Enter chassisDisable.
|
9. Enter configDownload -map to download port-to-area addressing mode configuration files to the local
|
| system.
10. Power-cycle the chassis. The system recovers.
|
11. Enter chassisDisable.
|
12. Enter configDownload -all to download system configuration data, including chassis and switch
|
| configuration for all logical switches, to the local system. All the licenses, configurations, and FCIP
tunnels are restored.
|
13. Enter reboot. The device becomes fully functional with the new CP blades.
|
14. Verify that each blade's power LED is green. If not, ensure that the CP blade has power and is firmly
|
| seated and that the ejectors are in the locked position.

Completing the replacement

|
About this task
Complete the following steps to complete the CP blade replacement procedure.
Procedure
1. Enter haEnable to re-enable HA on the active CP blade.
Note: The haEnable command will cause the standby CP blade to reboot. Wait until POST completes
before moving to the next step. POST is complete when the status LED on the CP blade returns to a
steady green state.
2. Enter haShow and verify that the command output includes "HA Enabled, Heartbeat Up". If it is not
yet enabled, re-enter the command until you have verified that redundancy is achieved.
Note: The haEnable command will cause the standby CP blade to reboot.
Chassis_1:admin> hashow
Local CP (Slot 2, CP1) : Active
Remote CP (Slot 1, CP0) : Standby, Healthy
HA Enabled, Heartbeat Up, HA State Synchronized
3. Enter firmwareShow to verify that the firmware version has been updated and that the versions are the
same on the two CP blades.
chassis:admin> firmwareshow -v
Slot NameAppl Primary/Secondary VersionsStatus
-----------------------------------------------------------
1CP0FOSv8.0.1STANDBY
v8.0.1
2CP1FOSv8.0.1ACTIVE *
v8.0.1
3SX6FOSv8.0.1
v8.0.1
4SX6FOSv8.0.1
v8.0.1
7SX6FOSv8.0.1
v8.0.1
8SX6FOSv8.0.1
v8.0.1
147
Control Processor Blades