Table of Contents
Advertisement
1. Connector latch
2. Power cable
8. Attach the cable restraint cover under the power cord connector using its two torx head screws (refer
to step 6).
Note: This retainer cover protects the power cord from being accidentally unlatched and
disconnected from the power supply.
9. If connecting to an AC power source, use the following steps. (If connecting to a DC power source,
go on to step 10.)
a. Make sure that you observe the electrical caution and danger statements in "Safety precautions"
on page 7 when connecting this power supply.
b. Make sure that AC power plug is attached to the power-source end of the HVAC/HVDC power
cord that meets your facility and local code requirements. For more information on the
HVAC/HVDC power cord available for these power supplies, refer to "Using HVAC/HVDC
power cords" on page 51.
50
SAN256B-6 Installation, Service, and User Guide
Advertisement
Table of Contents
