Figure 16. Rack kit parts
1 - Saddle
2 - Telco mid-mount mounting bracket (left)
3 - Telco mid-mount mounting bracket (right)
4 - 10-32 x .63 in.(1.60 cm) Phillips screws with square cone washer for racks that have rails with
round holes
5 - 10-32 clip nuts for racks that have rails with round holes
6 - 10-32 retainer nuts for racks that have rails with square holes
7 - Bracket adjusting screws
Assembling the rack hardware
Procedure
1. Loosen the two 10-32 adjusting screws securing the each mid-mount bracket to the saddle (refer to the
previous figure) and slide the brackets as far backward as possible.
2. Install the saddle to the equipment rack rails using the following steps while referring to the
following figure. Also refer to Figure 18 on page 36 for details on securing screws to equipment rack.
34
SAN256B-6 Installation, Service, and User Guide