Table of Contents
Advertisement
Installing the device in the rack
About this task
DANGER
18-32 kg (39.7-70.5 lbs)
Procedure
1. If a door is installed on your chassis, ensure that it is removed. Refer to procedures for removing and
replacing the device door in this guide.
2. Use a lift to raise the device to the correct level.
3. If applicable, lock the wheels of the lift.
4. Carefully lift the device and slide it into the rack.
5. Secure the device to the rack with six 10-32 screws with washers. Tighten the screws according to
specifications under "Torque requirements" on page 21.
Note: Screws, clip nuts, and retainer nuts to secure the device to the rack are provided in the device
hardware accessory kit.
Figure 15. Device and 27-31 in. (68.58 to 78.74 cm) kit installed in rack
1 - Screw locations for 10-32 x .5 in. (1.27 cm) Phillips screw with blue Loctite on threads or 10-32
x .63 in.(1.60 cm) Phillips screw with square cone washer for racks that have rails with round
holes. Use either 10-32 retainer nut for racks that have rails with square holes or 10-32 clip nut for
racks that have rails with round holes to retain screws.
32
SAN256B-6 Installation, Service, and User Guide
Use safe lifting practices when moving the product.
Advertisement
Table of Contents
