Table of Contents
Advertisement
DANGER
If a lift tool is not available, the director chassis must be depopulated completely before
installing it into the rack. Remove the power supplies, fan modules, all of the blades, the cable
management fingers, and the chassis door (if equipped). Install the empty chassis into the rack
following the chassis installation instructions. The weight of the empty chassis is 54 lb (24.5 kg)
and must be lifted by minimum 2 people. After securing the chassis to the rack, reinstall the
power supplies, fan modules, and the blades and proceed with the installation.
Parts list
The following parts are provided with the 8U Chassis 27-31 Inch Rail Rack Kit for Four-Post Racks.
Note: Not all parts may be used with certain installations depending on the device type.
Figure 22. Rack kit parts
1 - Left rail
2 - Right rail
3 - 10-32 x .5 in. (1.27 cm) Phillips screw
4 - 10-32 x .63 in.(1.60 cm) Phillips screw with square cone washer for racks that have rails with round
holes
5 - Alignment washer for racks that have rails with square holes
6 - Adjusting screw locations
39
Mounting the Device
Advertisement
Table of Contents
