Panasonic MINAS S Series Operating Manual page 79

Adjustments
If the machine is not stiff, vibration and noise may be generated due to the resonance by shaft
torsion, and you mey not be able to set-up the higher gains. You can suppress the resonance by 2
types of the filters.
1 .Torque command filter (Pr14 and Pr1C
Set the filter's time constant so that
the frequency components around the
resonance region can be attenuated.
You can obtain the cutoff frequency
(fc) by the following formula;
Cutoff frequency, fc (Hz) =
1/(2 \ x Parameter value x 0.00001)
2 .Notch filter (Pr1D and Pr1E
Adjust the notch frequency of the filter
to the resonance frequency.
Pr1D Notch
frequency
Pr1E
Notch width
selection
How to measure the resonance frequency of a machine system
1) Log-on PANATERM
2) Set the following parameters and measuring conditions. Note that the values shown below are
Resonance characteristics
only guidance.
• Decrease the value of Pr11 (1st Velocity Loop Gain) to 25 (to make the resonance frequency
moredistinguishable).
• Set the amplitude to 50 r/min (so that the torque may not saturate).
• Set the offset to 100 r/min. (to increase the amount of velocity detection information, and run
themotor in one-way rotation).
• Polarities: (+) for CCW and (-) for CW.
• Set the sampling rate to 1 (from a range between 0 and 7).
• Start the frequency characteristics analysis function.
<Notes>
• Before starting the measurement, make sure that the machine does not move beyond the limit.
Approximate speed = Offset (r/min.) x 0.017 x (Sampling rate + 1)
With a larger offset value, good results can be obtained, though the speed becomes higher.
• Set-up Pr21 (Real time auto tuning mode set-up) to 0.
<Notes>
• Set-up the offset larger than the amplitude setting, and with one-way rotation so that you can
obtainbetter results.
)
Set this about 10% lower than
the resonance frequency mea-
sured by the frequency charac-
teristics analysis function of
PANATERM .
"
Use the default value of 2.
" and open the frequency characteristics screen.
)
Gain
Anti-resonance
Characteristics of
notch filter
Gain
Notch
- 78 -
Resonance
Frequency
Frequency