Panasonic MINAS S Series Operating Manual page 66

2.Check LED status.
Make sure that the alarm code LED is not flashing.
Set the rotary switch to
default "0" position for
GAIN adjustment.
CN SIG
CN I/F
(Under the normal
operation, the alarm
indicator is OFF.)
CN MOTOR
LED color
Main power is on. Amplifier power is on.
Green
Flashing when warning occurs. (Overload,
Orange
excessive regenerative energy)
Alarm
Red
This indicator will start flashing when an alarm occurs.
Alarm codes (see page 60-65) are indicated by the number
of flash
(in orange and red)
Orange: Tens digits, Red: Unit digits
(Example)
When an overload (alarm code No.16) occurs:
The alarm indicator will flash in orange once and in red six
times.
orange red red
1 0. 0.
sec. 5 sec. 5 sec.
1 sec. 0.5 sec.0.5 sec.0.5 sec.0.5 sec.0.5 sec.
3. Set Parameters.
Prepare a personal computer and PANATERM
4. Input commands relevant to
the desirable control mode.
- 65 -
Meaning
red red red
0. 0. 0.
5 sec. 5 sec. 5 sec.
red
0.
5 sec.
After
2
seconds
.
®