Canon PRO-10 Series Manual page 767

1680 Seven flashes:
1681 Ink tank is not installed in the
correct position.
1700 Eight flashes:
Ink absorber is almost full.
2001 Nine flashes:
The digital camera or digital
video camcorder connected is
not compatible with this printer.
- Nine flashes:
The printer has not received a
response from the digital
camera.
1062 Eleven flashes:
2500 The Page Size setting does not
match the size of the paper
loaded in the printer./Automatic
Print Head Alignment failed.
Some ink tanks are not installed in the
correct position. (The lamps on the ink tanks
flash.)
More than one ink tanks of the same color
are installed. (The lamps on the ink tanks
flash.)
Confirm that the ink tanks are installed in the
appropriate positions.
Replacing an Ink Tank
The ink absorber is almost full.
The printer has a built-in ink absorber to hold
the ink used during Print Head Cleaning.
Press the printer's RESUME/CANCEL button to
continue printing. Contact the service center.
Check the device connected to the printer.
Printing photos directly is possible only with a
PictBridge compliant device.
A communication time out occurs if an operation
takes too long or if it takes too much time to
send data. This may cancel printing. In such
cases, disconnect and reconnect the USB
cable.
When printing from a PictBridge compliant
device, depending on the model or brand of
your device, you may have to select a
PictBridge compliant print mode on the device
before connecting it to the printer. You may also
have to turn on your device or select Play mode
manually after connecting the device to the
printer. Perform necessary operations before
connecting your device referring to its
instruction manual.
If the error is not yet resolved, check if you can
print another photograph.
When performing an ordinary print job:
Press the RESUME/CANCEL button on the
printer to clear the error. Then check the
Paper Size setting in the Page Setup dialog
and load paper that is the same size as the
setting and try printing again.
Set the printer not to detect the width of the
paper using the Canon IJ Printer Utility.
To set the printer not to detect the width of
the paper, open the Canon IJ Printer Utility,
select Custom Settings in the pop-up
menu, clear the Detect paper width check
box, and then click Apply.
To open the Canon IJ Printer Utility, see
Opening the Canon IJ Printer
* Select the Detect paper width check box
again once printing is complete, and then
click Apply.
When performing Automatic Print Head
Alignment:
Print head nozzles are clogged.
Press the RESUME/CANCEL button to
dismiss the error, and print the nozzle check
Utility.