Canon PRO-10 Series Manual page 118

Home > Overview of the Printer
Status with the Ink Lamps
C096
Checking the Ink Status with the Ink Lamps
1.
Make sure that the power is turned on, and open the paper output tray gently.
2.
Open the top cover, then press the RESUME/CANCEL button.
Replacing Procedure
3.
Check the ink lamp.
Close the top cover after checking the ink lamp status.
Replacing Procedure
The ink lamp is on.
The ink tank is correctly installed.
The ink lamp is flashing.
Flashing slowly (at around 3-second intervals)
Ink tank is running low. Prepare a new ink tank.
Note
When printing on A3 size or larger paper, ink may run out during printing. This may cause
blurred print results or horizontal white streaks.
Flashing fast (at around 1-second intervals)
- The ink tank is installed in the wrong position.
Or
- Printer detected ink out condition.
Make sure that the ink tank is installed in the correct position as indicated by the label on the print
head holder. If the position is correct but the lamp flashes, there has been an error and the printer
cannot print. Check the Alarm lamp on the printer.
Alarm Lamp Flashes Orange
> Replacing an Ink Tank > Checking the Ink Status
...... Repeats
...... Repeats
> Checking the Ink