Canon PRO-10 Series Manual page 517

: Poor
Type of encryption is displayed as follows.
Blank: No encryption
WEP: WEP is set
WPA: WPA is set
WPA2: WPA2 is set
2.
Refresh
Click to update the list of access points when your target access point is not detected.
If the target access point is set to a closed network (the stealth mode), click Cancel to return to
the previous screen and enter the network name (SSID) in Network (SSID).
Note
Make sure that the access point is turned on.
3.
Set
Click to set the network name (SSID) in Network (SSID): on the Wireless LAN sheet.
Note
The WEP Details screen, the WPA Details screen, or the WPA2 Details screen appears if
the selected access point is encrypted. In this case, configure the details to use the same
encryption settings set to the access point.
Access points that cannot be used by this printer (including those configured to use different
encryption methods) are displayed grayed out and cannot be configured.
Page top