Canon PRO-10 Series Manual page 526

Home > Overview of the Printer
Settings > Monitoring Wireless Network Status
N018
Monitoring Wireless Network Status
Note
When using the printer over the Wired LAN, you cannot monitor network status.
1.
Start up IJ Network Tool.
Starting up IJ Network Tool
2.
Select the printer in Printers:.
3.
Select Status from the View menu.
The Status screen is displayed and you can check the printer status and connection performance.
1. Signal Level:
Indicates the strength of the signal received by the printer, ranging from 0% to 100%.
2. Link Quality:
Indicates the signal quality excluding the noise while communicating, ranging from 0% to 100%.
Important
If the indicated value is low, move your printer closer to the wireless network device.
3. Advanced Measurement...
Click to examine the connection performance between the printer and the access point. Follow
the instructions on the screen to start measuring and display the status. Measurement takes a few
minutes.
When is displayed in Connection Performance between the Printer and the Access
Point, the printer can communicate with the access point. Otherwise, refer to displayed
comments and Help for improving the status of communication link, and click Remeasurement.
Check that the printer and the access point are located within the wireless connectivity range
with no obstacles between them.
Check if the distance between the printer and the access point is not too far.
If they are too far, move them closer together.
Check that there is no barrier or obstacle between the printer and the access point.
In general, connection performance decreases for communications through walls or between
different floors. Adjust the locations to avoid such situations.
Check that there are no sources of radio interference near the printer and the access point.
The wireless connection may use the same frequency band as microwave ovens and other
> About Network Communication > Changing and Confirming Network