REFERENCE
Pass the USB cable and the power cable unit
through the following place.
11. Secure the USB cable and the power cable
unit with the cable clamps.
REFERENCE
If you removed the cable clamps in step
7, securely attach them to their original
positions.
12. Attach the feed inlet cover with the four
screws.
13. Pull out the USB cable and the power cable
unit from the operator's side to take up the
slack in the cable.
REFERENCE
If there is much slack in the cable, the USB
cable and the power cable unit may not reach
the connectors on the main PCB unit.
14. Attach the banding band to the ferrite core
(small) and make a loop.
Chapter 2
Printer Unit (NIC) Type D1
8
Operator's side
Paper infeed side
Paper infeed side
Banding band
2
85