Removing The Battery Pcb Unit; Removing The Motor Pcb Unit - Ricoh DD5450 Field Service Manual

Chapter 4 Exterior
1

(11) Removing the Battery PCB unit

WARNING
● Always remove the power cord plug from
the outlet before replacing a PCB unit.
1. Remove the front cover.
2. Remove the control panel.
3. Remove the two screws.
4. Disconnect the connector to remove the
battery PCB unit.

(12) Removing the Motor PCB unit

WARNING
● Always remove the power cord plug from
the outlet before replacing a PCB unit.
1. Remove the rear cover.
2. Remove the control panel.
3. Remove the three screws and disconnect the
three connectors to remove the motor PCB
unit.
184
→See (2) above
→See (6) above
→See (4) above
→See (6) above
Battery PCB unit
Screws
Cover
Screw
Motor PCB unit
Screw