Ricoh DD5450 Field Service Manual page 353

HELP-046
MASTER CLAMP MARGIN(mm)
+0.0
1.
M-MAKE SPEED MAGNIFICATION(%)
−0.5
2.
M-MAKE FEED VOLUME MAGNIFICATION(%)
+0.3
3.
● Operation procedure
1.
Call the HELP mode "H-046".
Enter "046" by the NUMERIC keys and then press the
PRINT key.
2.
Adjust the master feed.
Adjustment
1. Select and touch the item to be adjusted.
Master clamp margin
● Make adjustment so that the master edge is seen
from the check hole of the master clamp. The
master clamp margin becomes shorter by "-" and
longer by "+".
M-Make speed magnification
● Adjust so that the vertical length of the two
100 mm squares made up in the HELP-30 test
pattern is 200±0.5 mm.
M-Make feed volume magnification
● Press the MASTER MAKING key to feed the master
to the master edge sensor. The master is cut into
the length of 200 mm. Adjust the master make
horizontal feed volume magnification so that the cut
master length is 200±0.5 mm.
2. Enter the value by the NUMERIC keys or change the value
by the PRINT POSITION
● Press the HOME key to invert "+"and "-"of
the selected set value.
● Press the C (clear) key to return the selected set
value to the value before change.
X
3. Press the = key to store the set value.
3.
Return to the HELP mode.
Press the STOP key. The HELP mode selection display will reappear.
→ To exit the HELP mode
→ To access another HELP mode : Enter the desired mode number
Chapter 8 HELP Mode Function and Operation Procedures
3
(1) Master Feed Adjustment
Page 1:
● Adjustment.
MASTER CLAMP MARGIN
M-MAKE SPEED MAGNIFICATION
M-MAKE FEED VOLUME MAGNIFICATION
keys.
: Turn the power switch OFF.
using the numeric keys.
(2 pages in total)
HELP-046
MASTER CLAMP MARGIN(mm)
+0.0
1.
M-MAKE SPEED MAGNIFICATION(%)
−0.5
2.
M-MAKE FEED VOLUME MAGNIFICATION(%)
+0.3
3.
HELP-046
MASTER CLAMP MARGIN(mm)
+0.0
1.
M-MAKE SPEED MAGNIFICATION(%)
−0.5
2.
M-MAKE FEED VOLUME MAGNIFICATION(%)
+0.3
3.
８
351