Ricoh DD5450 Field Service Manual page 182

Chapter 4 Exterior
1
4. Remove the screw to remove the sheet.
(S tight hexagon head WH rounded end screw
3 x 6)
5. Remove the two screws to remove the LCD
module unit.
(P tight pan head WH screw 3 x 8)
6. Remove the four screws to remove the LCD
module.
(S tight hexagon head WH rounded end screw
3 x 6)
Reinstallation
IMPORTANT
● Connect the cable unit in the correct
direction.
Connect it with the terminal surface down.
180
Sheet
Screw
Screw
Screw
Screw
2. Pull out the cable unit.
1. Release the lock.
Recommended
● Carefully release
the lock while
holding it between
your fingers as
shown in the above
figure.
Screw
Screw
Incorrect
● If you release the
lock as shown in
the above figure,
it opens sharply
and may damage
the connector.