Ricoh DD5450 Field Service Manual page 385

3.
Advanced set-up
1. Select and touch
ENABLE/ DISABLE
the TEST PRINT key.)
2. Select and touch
ENABLE
the TEST PRINT key.)
3. Touch the place to enter and then enter the value of IP address
with NUMERIC keys .
4. Touch the place to enter and then enter the value of SUB NET
MASK with NUMERIC keys .
5. Touch the place to enter and then enter the value of DEFAULT
GATEWAY with NUMERIC keys .
6. Touch "OK" (or press the
Initialize
1. Select and touch YES/NO. (You can also select by pressing
X
the = key.)
● Touch "YES". FS-100U is initialized. (same as factory setting)
Return to the HELP mode.
4.
Press the STOP key. The HELP mode selection display will reappear.
→ To exit the HELP mode
→ To access another HELP mode : Enter the desired mode number
Chapter 8
on DHCP. (You can also select by pressing
/ on RARP. (You can also select by pressing
DISABLE
X
= key.) The setting is sent to FS-100U.
: Turn the power switch OFF.
using the numeric keys.
HELP Mode Function and Operation Procedures
3
HELP-072
NETWORK
ADVANCED SET-UP
DHCP
RARP
IP ADDRESS
SUB NET MASK
DEFAULT GATEWAY
HELP-072
NETWORK
INITIALIZE?
YES
ENABLE DISABLE
ENABLE DISABLE
000 000 000 000
000 000 000 000
000 000 000 000
OK
NO
８
383