Ricoh DD5450 Field Service Manual page 309

HELP-005
DRUM SECTION
MASTER DETACH POSITION ADJUSTMENT
.
2
+00
● Operation procedure
Call the HELP mode "H-005".
1.
Check that the master is wound around the drum. Then enter
"005" by the NUMERIC keys and then press the PRINT key.
2.
Change the screen.
Touch the arrow on the screen lower right three times to
switch to Page 4.
3.
Check operation.
● Press the MASTER MAKING key.
Every time this key is pressed, the drum stops at the master detach
position.
4.
Adjusting the master detach position.
● Normally, adjustment is not made.
Adjustment
1. Enter the value by the NUMERIC keys or change the
value by the
● Reference value : -10 - +10
● Press the C (clear) key to return the set value to the default.
X
2. Press the = key to store all set values.
5.
Return to the HELP mode.
Press the STOP key.
The HELP mode selection display will reappear.
→ To exit the HELP mode
→ To access another HELP mode : Enter the desired mode number
Chapter 8 HELP Mode Function and Operation Procedures
3
(4) Adjusting/Checking the Drum Section
Page 4:
● Adjusting the master detach position.
Normally, adjustment is not made.
PRINT POSITION keys.
: Turn the power switch OFF.
using the numeric keys.
(4 pages in total)
HELP-005
DRUM SECTION
DRUM: DRUM POSITION 1
1 :MAIN MOTOR ENCODER SENSOR
0 :DRUM POSITION 1 SENSOR
1 :DRUM POSITION 2 SENSOR
0 :DRUM SWITCH
1 :A4 DRUM SENSOR
Touch
0 :COUNTER DRUM DETECTION
1 :JOG SWITCH
1 :PAPER EJECT SWITCH
251 :DRUM MASTER SENSOR
HELP-005
DRUM SECTION
MASTER DETACH POSITION ADJUSTMENT
.
2
+00
８
307