Ricoh DD5450 Field Service Manual page 300

Chapter 8 HELP Mode Function and Operation Procedures
3
HELP-001
SOFTWARE UPDATE
MAIN PCB
PANEL PCB
RELAY PCB
TAPE DISPENSER PCB
● Operation procedure
Call the HELP mode "H-001".
1.
Enter "001" by the NUMERIC keys and then press the
PRINT key.
Select PCB.
2.
Select and touch the PCB to be upgraded.
(The right figure shows the case when the main PCB is
selected.)
To update the main PCB:
3.
Touch "USB INTERFACE" or "USB FLASH DRIVE" to update
the main PCB.
"Download available" is displayed and
the printer is ready to receive the updated version.
The updated version is sent from PC by using the
Program Update Utility. (For Windows XP/Vista/7/
8 only)
The updated data selection screen appears,
Select the updated data.
IMPORTANT:
● Do not turn off the power during updating; otherwise you may need to replace the main PCB.
● If you turn off the power during updating the main PCB, set the DIP SW1 on the main PCB as follows
and then update the main PCB again. 1: ON, 2: OFF, 3: OFF, 4: OFF
● If you turn off the power during updating the panel PCB, set the DIP SW1 on the main PCB as follows
and then update the panel PCB again. 1: ON, 2: OFF, 3: ON, 4: OFF
● Before updating the relay PCB, turn off the power and set the DIP SW1 on the main PCB as follows.
4: ON
After updating is complete, turn off the power and return the DIP SW1 as follows. 4:OFF
4.
Return to the HELP mode.
Press the STOP key.
The HELP mode selection display will reappear.
→ To exit the HELP mode
→ To access another HELP mode: Enter the desired mode number
298
ROM Update
Update ROM via USB INTERFACE or the USB FLASH DRIVE.
PCBs to be upgraded :
● Main PCB
● Panel PCB
● Relay PCB
● Tape dispenser PCB (with Tape Dispenser installed)
: Turn the power switch OFF.
using the numeric keys.
HELP-001
SOFTWARE UPDATE
MAIN PCB
PANEL PCB
RELAY PCB
TAPE DISPENSER PCB
HELP-001
SOFTWARE UPDATE
USB INTERFACE
USB FLASH DRIVE