Chapter 2
Tape Dispenser Type D1
6
2. Lift the lever until it clicks.
3. Set the tape roll.
Make sure that the tape core is surely locked
at the stopper.
IMPORTANT
If the tape core is not locked correctly, the
tape is not fed correctly.
4. Set the end of the tape as shown in the
figure.
Pull out the end of the tape for about 3 cm
from the blade.
WARNING
The blade to cut the tape is uncovered.
Do not touch or keep your hands or
fingers away from it.
IMPORTANT
When setting the tape, make sure that there is
no slack in the tape.
When the tape is slack, the tape dispenser may
fail to eject the strip properly.
66