Ricoh DD5450 Field Service Manual page 79

15. Secure the USB cable unit with cable
clamps.
REFERENCE
If you removed the cable clamps in step
10, securely attach them to their original
positions.
16. Attach the feed inlet cover with the four
screws.
17. Pull out the USB cable unit from the
operator's side to take up the slack in the
cable.
REFERENCE
If there is much slack in the USB cable
unit, the USB cable unit may not reach the
connector on the main PCB unit.
18. Connect the USB cable unit to the CN1 on
the Main PCB unit.
REFERENCE
A banding band is attached to the USB cable
of the LAN interface to distinguish.
19. Attach the rear cover with the four screws.
Chapter 2 Printer Unit (USB) Type D1
7
Paper infeed side
Paper infeed side
CN1
Paper infeed side Paper ejection side
２
Operator's side
77