Reinstallation
IMPORTANT
● When replacing the flat cable, bend it as
shown in the right figure before installation.
● When replacing the touch panel or LCD
The LCD and the touch panel are attached
together. If you replace either one, follow the
procedures below.
IMPORTANT
● The touch panel have two sides (front,
reverse). Take note of the correct side.
1. Separate the touch panel and the LCD that are
attached with the adhesive tape. Remove the
adhesive tape from them.
2. Prepare two pieces of double-sided tape (width:
5 mm, length: same as touch panel length).
Affix the tapes to the LCD.
Chapter 4
42 mm
Panel PCB unit side
35 mm
Terminal surface
(down)
71 mm
LCD
Double-sided tape
Exterior
1
LCD module
side
Terminal
surface
(down)
Bend to match
the corners to
each dimension.
4
Touch panel
Double-sided tape
181