8. Attach the USB PCB unit with the supplied
four screws.
9. Connect the USB cable unit to the connector
of the USB PCB unit.
10. Remove the four screws to remove the feed
inlet cover.
R
ENCE
EFER
When the USB cable is already passed
through, it is easier for you to work if you
remove the cable clamps with a long nose
pliers from the feed inlet cover.
11. Pass the USB cable unit through the frame
opening.
12. When the LAN interface is not attached, go
to step 14.
Chapter 2
Printer Unit (USB) Type D1
7
Non-operator's side
Non-operator's side
Paper infeed side
Non-operator's side
2
75