Ricoh DD5450 Field Service Manual page 42

Chapter 2 ADF DF7010
3
4. Remove the 2 pcs. of screw to remove the front
cover.
5. Remove the 3 pcs. of screw to remove the
cover while sliding in the arrow direction
(operating side). And then, install the jump
stand in the reverse procedure to removing.
IMPORTANT
● Glass is installed on the jump stand. Avoid
touching the glass while handling the jump
stand.
● Screws for both ends of the jump stand are
dedicated screw. Be sure to use the same
screw.
6. Install the ADF using the 2 pcs. of screw.
40
● remove the cover
Non-operator's side
Cover
Operator's side
● install the jump stand
Non-operator's side
Jump stand
Operator's side