Chapter 4
Scanner Section
2
Reinstallation
Install the slider B first and then slider A.
● Required items
Two Slider A installation jigs
Four Set screws
1. Move the slider A by rotating the timing
pulley to align the frame holes with the slider A
positioning holes. (See the figure on the right.)
IMPORTANT
● Do not move Slider A with hand.
2. Install the two slider A installation jigs with the
four screws.
3. Secure the wire with the two screws.
4. Remove the four screws to remove the two slider A
installation jigs.
5. Install the LED lamp with the two screws.
(Pan head screw with spring plain washer 3 x 6)
190
Slider A installation jig
Align hole positions
Jig
Screw
Insert the jig to
secure the wire.
Slider A installation jig
Screw
Slider A
Screw
Jig