Ricoh DD5450 Field Service Manual page 354

Chapter 8 HELP Mode Function and Operation Procedures
3
HELP-046
M-MAKE HORIZONTAL START POS.(mm)
+0.0
4.
M-MAKE VERTICAL START POS. (mm)
+0.5
5.
MASTER LENGTH ON DRUM (mm)
+00
6.
● Operation procedure
1.
Call the HELP mode "H-046".
Enter "046" by the NUMERIC keys and then press the
PRINT key.
2.
Change the screen.
Touch the arrow on the screen lower right once to switch to
Page 2.
3.
Adjust the master feed.
Adjustment
1. Select and touch the item to be adjusted.
M-Make horizontal start position
● Normally adjustment is not made. (default:+0.0)
M-Make vertical start position
● Adjust so that the vertical length of the two 100 mm squares made up
in the HELP-30 test pattern is 200±0.5 mm.
Master length on drum
● Normally adjustment is not made. (default:+0,0)
2. Enter the value by the NUMERIC keys or change the value
by the PRINT POSITION
● Press the HOME key to invert "+"and "-"of the
selected set value.
● Press the C (clear) key to return the selected set
value to the value before change.
3. Press the
4.
Return to the HELP mode.
Press the STOP key. The HELP mode selection display will reappear.
→ To exit the HELP mode
→ To access another HELP mode : Enter the desired mode number
352
(2) Master Feed Adjustment
Page 2:
● Adjustment.
M-MAKE HORIZONTAL START POS.
M-MAKE VERTICAL START POS.
MASTER LENGTH ON DRUM
keys.
X
= key to store the set value.
: Turn the power switch OFF.
using the numeric keys.
(2 pages in total)
HELP-046
MASTER CLAMP MARGIN(mm)
+0.0
1.
M-MAKE SPEED MAGNIFICATION(%)
−0.5
2.
M-MAKE FEED VOLUME MAGNIFICATION(%)
0.3
Touch
3.
HELP-046
M-MAKE HORIZONTAL START POS.(mm)
+0.0
4.
M-MAKE VERTICAL START POS. (mm)
+0.5
5.
MASTER LENGTH ON DRUM (mm)
+0.3
6.