Standard value
● Check that the clearance between the master ejection
box's rubber roller and the master clamp plate is
within the range given below.
Item
Clearance between the master
clamp lever and the master clamp
opening/closing lever
If the clearance is outside the standard range
1.
1. Loosen the fixing screw, then adjust rotating
the B/C mode shade plate.
Chapter 5
Master making / Master Feed / Ejection Section
2
Standard value
4.0 - 5.0 mm
Master clamp lever
Master clamp
opening/closing lever
4.0-5.0 mm
固定ネジ
Fixing screw
開く
Clamp sensor 1
(B mode)
B/C mode shade plate
5
233