Attaching/Removing Auto Sheet Feeder Fd-A09 (Optional Accessory); Attaching - Konica Minolta FD-9 Instruction Manual

Preparations

Attaching/Removing Auto Sheet Feeder FD-A09 (optional accessory)

❙ ❙
The optional Auto Sheet Feeder FD-A09 can automatically feed a stack of test charts into the FD-9. Up to 100 test charts can be placed in
the Auto Sheet Feeder, and they will be automatically fed into the FD-9 one by one to be scanned.

Attaching

• If the Paper Guide is attached to the FD-9, remove it before proceeding. See p. 13.
1
Unplug all cords and cables (AC adapter power cord, USB cable, LAN cable) from the FD-9.
2
While holding the cover of the FD-9 closed, tilt the FD-9
back so that it rests on its back side.
3
Push down on the tab of the Auto Sheet Feeder connector
cover, pull the cover open, and remove it.
• Please store the cover carefully so that it will not be lost or broken.
4
Return the FD-9 to the normal upright orientation.
5
Place the Auto Sheet Feeder FD-A09 on a flat surface.
6
Lift the FD-9 up, align the Auto Sheet Feeder alignment
holes on the bottom of the FD-9 with the alignment pegs
on the Auto Sheet Feeder, and slowly lower the FD-9
straight down onto the Auto Sheet Feeder until it clicks in
place.
14