Preparing The Machine; Installing The Heat Shields - Toro Polar Trac Cab 30474 Operator's Manual

1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface, lower the
cutting unit to the lowest height-of-cut setting,
shut off the engine, and remove the key.
2. Disconnect the battery cable connected to the
negative (-) battery terminal.
3. Allow the engine coolant to cool and then drain
the coolant from the machine; refer to the
machine Service Manual.
4. Remove the hood from the machine and set it
aside; refer to the machine Service Manual.
2

Installing the Heat Shields

Parts needed for this procedure:
1 Rear-panel shield
1 Under-seat shield
Installing the Rear-Panel Shield
1. Move the seat forward to allow you to have
access to the rear panel.
2. Toggle the 3 swell latches and remove the rear
panel (Figure 3).
1. Swell latch
3. Clean back of the plate to ensure proper
adhesion when you apply the heat shield.
4. Remove the backing and apply the rear-panel
shield to the engine side of the rear panel
(Figure 4).
1. Rear panel
2. Rear-panel shield
Note:
Center the rear-panel shield along the
width of the plate leaving 29 mm (1-1/8 inches)
from each edge
5. Set the panel aside.
Installing the Operator-Deck
Shield
1. Release the seat latch and tilt the seat forward.
2. Disconnect the seat-switch on the bottom of the
seat deck from the wire harness
9
Figure 3
2. Back panel
Figure 4
3. 29 mm (1-1/8 inches)
(Figure 4).
(Figure
g032347
g032348
5).