Table of Contents
Advertisement
Figure 105
1. Attachment assembly
4.
Use jack stands to support the front of the winter
frame.
5.
Remove the front wheels from the winter frame.
6.
Remove the tracks from the winter frame.
7.
Install the front wheels to the winter frame; refer
to
Installing the Wheels (page 38)
8.
Use a floor jack to lower the winter frame to the
ground.
9.
Install and tighten the flat washer (1/2 inch) and
locknut to the bogie-pivot assembly
Disconnection the Hydraulic
Hoses
1.
Place a suitable drain pan underneath the
control valve
(Figure
2.
Disconnect the supply hose from the tube
connector and pull it out of the through hole
(Figure
106).
2. Attachment-assembly
pivot
(Figure
104).
106).
g032731
1. Through hole
2. Supply hose
3. Tube
3.
Disconnect the return hose from the control
valve
(Figure
4.
Place caps on the fittings for seasonal storage.
Note:
Wipe up any fluid that spilled.
Disconnecting the Wire Harness
1.
Remove 5 bolts securing the rear cover to the
cab
(Figure
1. Rear cover
2.
Remove any cable ties securing the auxiliary
wire to the cab and pull it toward the machine.
3.
Disconnect the machine wire harness from the
cab wire harness
46
Figure 106
4. Return hose
5. Control valve
106).
107).
Figure 107
2. Bolt (3/8 x 3/4 inch)
(Figure
108).
g032630
g032665
Advertisement
Table of Contents
