Figure 108
1. Machine wire harness
4.
Secure each wire harness for seasonal storage.
Disconnecting the Cab Hoses
1.
Disconnect the washer tube, heater-supply
hose, and heater-return hose
Figure 109
1. Washer tube
2. Heater-supply hose
2.
Remove any cable tie that secure the drain tube
to the machine
(Figure
3.
Pull all hoses and tubes out of the grommets
and secure them for seasonal storage.
4.
Use the hose plugs to cap the hoses for
seasonal storage.
5.
Replace the winter grommet with the summer
grommet
(Figure
2. Cab wire harness
(Figure
109).
3. Heater-return hose
4. Drain tube
109).
110).
g032664
1. Winter grommet
6.
Install the rear cover; refer to
Cover (page 36)
Note:
Wipe up any spilled fluid.
Disconnecting the Cab
1.
Remove the bolts securing the cab-mount
bracket to the ROPS tube at the rear of the cab
frame
(Figure
g032663
1. Flange nut (1/2 inch)
2. Cab-mount bracket
3. Bolt (1/2 x 3-1/4 inches)
2.
Remove the 2 bolts securing the access cover
on each side of the machine
47
Figure 110
2. Summer grommet
Installing the Rear
111).
Figure 111
4. Locknut (3/4 inch)
5. ROPS tube
6. Bolt (3/4 x 3-1/2 inches)
(Figure
g032851
g032662
112).