Installing The Wire Harness - Toro Polar Trac Cab 30474 Operator's Manual

Securing the Washer Hose
1. Arrange the R-clamp around hose connector
(Figure 36).
Figure 36
1. Nut (1/4 inch)
2. R-clamp
2. Use the carriage bolt (1/4 x 3/4 inch) and nut to
secure R-clamp to the hose bracket
3. Torque the bolt to 1017 to 1243 N∙cm (90 to 110
in-lb).
g032523
3. Hose bracket
4. Carriage bolt (1/4 x 3/4
inch)
(Figure 36).
8

Installing the Wire Harness

Parts needed for this procedure:
1 Wire harness
1 Relay
1 Fuse (60 A)
2 Fuse (10 A)
3 Cable tie
Wire harness fuse block—Toro Part No. 92-2641
1
(purchased separately)
Key start harness—Toro Part No. 107-0672
1
(purchased separately)
Assembling the Wire Harness
1. Assemble the following components to the wire
harness (Figure
21
37).