Table of Contents
Advertisement
Figure 82
1. Through hole
2. Supply hose
3. Tube
6.
Connect the return hose to the control valve
(Figure
82).
7.
Tighten all hose fittings.
Note:
Do not secure the hoses to hot or moving parts.
Installing the Wheels
1.
Install the wheel onto the hub
Figure 83
1. Hub
2. Wheel
2.
Use the lug nuts to secure the wheels to the
frame
(Figure
83).
3.
Torque the lug nuts to the 88 to 115 N∙m (65 to
85 ft-lb) in the following order
g032630
4. Return hose
5. Control valve
(Figure
83).
g032628
3. Lug nut
(Figure
84).
Installing the Tracks
CAUTION
The track guides have many pinch points.
Coming into contact with one of these pinch
points could cause severe personal injury.
Carefully grasp the rubber track on the outer
edges outboard of the steel guides when
moving the track.
1.
Place 2 jack stands underneath the rear of frame
to support the machine when you lift the front of
the machine
(Figure
1. Machine frame
2.
Remove the locknut and washer from the
threaded stud on the bogie-stop assembly and
set them aside
38
Figure 84
85).
Figure 85
2. Jack stand (2)
(Figure
86).
g032629
g032669
Advertisement
Table of Contents
